PocketWizard FlexTT5-Canon Manuel du propriétaire télécharger pdf (Page 62)

Flex TEST button

Reset

The MiniTT1 and FlexTT5 can be reset in the eld.

There are two types of reset.

RESET A: Returns both C.1 and C.2 to the channels you last set

in the PocketWizard Utility. Reset A is primarily used for resetting

channels that were taught in the eld.

1. Turn the radio off

2. While holding TEST, slide the power switch to C.1 (C.1 and C.2

are always reset together).

3. Hold TEST for a few moments until you see 2 green blinks, then release TEST. The channels

are restored to their last Utility values. If you’ve never set the channels using the Utility, then

the channels are restored to factory defaults.

RESET B: Returns all of your radio’s settings, including channels and all settings from the

PocketWizard Utility, to factory defaults.

1. Turn the radio off

2. While holding TEST, slide the power switch to C.1 (C.1 and C.2 are always reset together).

3. Hold TEST for ~10 seconds until you see 4 green blinks, then release TEST. The radio is reset

to factory defaults.

Default Settings:

ControlTL Tx Channel = 1 HyperSync Offset = -170

Standard Tx Channel = 1 Remote TTL Flash Sleep Delay = Disabled

Use ControlTL for Rx Channel = Enabled Flash Idle Time Out Mode = Disabled

ControlTL Rx Channel = 1 Force TTL Master Mode = Disabled

Camera Model = Auto Bottom Shoe = Enabled

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 73 74

Pas de commentaire

PocketWizard FlexTT5-Canon Manuel du propriétaire Page 62